Arida

Compact dehumidifier with sorption. A truly efficient dehumidifier that allows you to collect moisture from the air even at low temperatures. Unlike cheaper condensation dehumidifiers, this sorption dehumidifier can collect moisture when the temperature drops even to zero degrees. The special structure and materials of the sorption dehumidifier enable the space to remain dry even in Finland's challenging spring and autumn weather, when temperatures fluctuate on both sides of zero degrees. In these weather conditions, humidity in the spaces is the most challenging and it can cause odors, mold, rust and corrosion. Dry indoor air is also significantly more comfortable when, for example, all interior surfaces are not damp and slippery when you arrive on a boat.

A dehumidifier for those who need to dry a small space in all temperatures above zero. This dehumidifier is well suited for:

- For a motorhome
- For a caravan
- To the boat
- To a small basement
- To the summer cottage

The dehumidification capacity is around 3 litres per day. This is around half that of most other sorption dehumidifiers, making it suitable for solving moderate humidity problems. The advantage of this compact size is that it takes up little space and consumes little power.

The dehumidifier can be used at low or high power. In this case, it only uses 200 watts or 320 watts. This is important in campsites, ports and other places where electricity is limited. The device's efficient sorption feature makes the device cost-effective, as it does not have to run as long as compressor models to remove the same amount of moisture from the air. Shorter operating time -> lower overall consumption. The device requires shore power, i.e. 230V, to operate.

The size is only 414mm high, 219mm wide and 170mm deep. The water tank has a capacity of 1.8 liters. It is possible to connect a drain hose to the tank and empty it directly into, for example, a sink.

Can be mounted on the wall, used as a stand or hung on the wall. Wall brackets are included in the package, so you don't need to buy them separately.

A drain hose is included if you want to drain the water directly into the drain. This is attached directly to the water tank.

The device does not have a compressor, so it is very quiet. The only sound you hear is the hissing sound from the fan due to ventilation. The device does not vibrate. The sound level is measured at 33 decibels on low power and 47 decibels on high power.

The device has a built-in safety feature that allows for customized steering, tilt, and internal temperature monitoring to prevent overheating.

Automatic start after power failure.

Energy saving functions, the device also has a timer, allowing you to schedule use for 1-7 hours.

Arida Færder is an efficient and compact dehumidifier for boats where space is limited but humidity control is important. Arida Færder is a permanently installed sorption dehumidifier that removes moisture from the boat's interior air and prevents mold, corrosion and musty odors. The device has WiFi control and an external, wired hygrostat. The dehumidifier also works excellently in cold conditions and blows moisture out of the boat as moist air - it does not collect water in the tank.

Færder is the same device as the Arida Pro S13 Wifi, designed for households, and the only difference is that Færder removes a maximum of 8 liters per day while the S13 Pro removes a maximum of 13 liters per day.

The perfect dehumidifier for your boat

Does the air inside your boat feel damp and musty? Are there visible signs of corrosion on the wires or are the textiles damp? Arida Færder lowers the relative humidity of the air and prevents the formation of mold, fungus and odors. The end result is a fresher and more pleasant indoor air without unpleasant odors and moisture-induced damage.

In addition, the device has a HEPA filter that cleans the air of dust and impurities.

Easy installation

The dehumidifier is installed in a suitable location on the boat and secured securely. It can be placed, for example, inside a cabinet, under a bench or in a technical space.

• The dryer sucks moist air from the boat through a 90 mm hose.
• The dried air is returned to the boat through another 90 mm hose.
• Moisture is removed from the boat as humid exhaust air through a 40 mm hose and a hull penetration.

Works even in cold conditions

Arida Færder uses rotor-driven sorption technology, which ensures excellent drying performance at all temperatures, even in freezing conditions. Whether it is a warm summer day or cold winter storage, Arida Færder dries efficiently. This is especially important on boats where the temperature fluctuates a lot. The device is also excellently suited for freezing conditions.

HEPA filter – cleaner air and longer service life

The Arida Færder dehumidifier has a HEPA filter that protects the device from dust, exhaust particles, salt crystals and other impurities. Over time, these can reduce the device's performance and, in the worst case, cause dangerous situations. Therefore, it is a good idea to change the filter once a season to maintain the device's efficiency and safety.

The Arida Pro S12 V2 is an updated version of the Pro S12 model and effectively removes moisture from boats, homes, garages or other humid environments. Its compact size makes it ideal for installation in tight spaces. The dehumidifier works by blowing away moisture as humid air, while the dried air is directed back into the room to maintain a lower humidity level. The device is supplied with an external hygrostat (controller/, which allows you to easily adjust and control the humidity level according to your needs.

With an efficient daily capacity of up to 12 liters and an air flow of 130 m³ per hour, even the most humid rooms become dry and comfortable. The device is frost-resistant and suitable for use in all temperatures.

Features:

• Compact design: Perfect for boat, RV, camping, basement, etc.
• Durable metal construction: Ensures longevity and reliability.
• Efficient dehumidification: Up to 12 liters of water per day.
• Air flow: 130 m³ of air per hour.
• Frost resistant: Works in temperatures from -20 °C to +40 °C.
• No tank to empty: Removes moisture with the air.
• Quiet operation: Sound level only 52 dB.
• Easy installation

The metal feet and practical design make installation easy. The mounting feet can be turned to the side and have holes for securing the dryer securely. The dryer can be mounted on a wall, ceiling or shelf. The air filter is easily accessible for cleaning or replacement. Air circulation can be optimized by connecting the dryer to air hoses.

Hygrostat

The device has a built-in hygrostat that allows you to easily adjust and monitor the humidity level. In addition, an external hygrostat is included for flexibility. The hygrostat controls the dehumidifier to maintain a constant humidity level. The external hygrostat is supplied with a cable and can be placed further away from the device, allowing the humidity to be measured in a different room from where the dehumidifier is located.

Air hose connections

The Arida Pro S12 V2 has a 125 mm hose connection, which allows humid air to be taken from another room. In addition, dry air can be directed to another room. The use of hoses is not mandatory, but it improves air circulation and allows for more precise humidity control.

Air filter

The air filter is attached to the air intake of the device in a frame. It is easy to remove and clean or replace using two clips.

Package contents:

• Sorption dryer
• 1 external humidistat.
• 1 hose for intake air.
• 1 external valve for intake air.