Shore Power Systems

Accessories that fit the RATIO shore power system. Easy installation with plug-in connector. No need for a qualified electrician to install.

A galvanic isolator is connected in series with the protective ground between the electrical connection and the shore power center and protects against corrosion caused by leakage currents.

The Ratio AC16 shore power system provides a complete electrical system for your boat, and all components are Plug & Play and do not require installation by a qualified electrician. The shore power system is flexible and very easy to expand or change when new equipment is added to the boat. All components are installed with quick connectors, and no tools are required for the actual installation. Additional sockets can be installed with a cable splitter and an extension cable of 1-5m. A galvanic isolator is recommended to minimize galvanic currents.

Ration shore power package - you get access to 230 V for your boat. The package is intended for slightly smaller boats. With the boat's shore power, you can easily charge batteries and use other 230V electrical devices, such as tools, coffee makers, microwaves or anything else you need.
Install the socket outside the boat and use it to connect the shore power cable, which you pull from the CEE socket on the dock. CEE is a standard that can be found on docks in ports, for example. The power centre is installed in a suitable place inside the boat. At the bottom is a standard earthed socket (schuko), the same type as in homes. Here you can connect the devices you want to use. Adapters are also available in case you need to connect the shore power cable to a standard schuko socket.
The electrical center is also equipped with a ground fault circuit interrupter and an LED that indicates that power is present.

This complete set includes:
Electrical center (16A/250V) with cable 4.30m.
Stainless steel socket.
Ground power cable (15m).