Steering cables
Boat control cables in different thicknesses and lengths.Tuoteryhmät
Steering cables -ryhmän tuotteet
Kampanja
Required cable length when using a transom or engine well mount:
- Measure the distance from the center of the steering shaft to the center of the motor, around the steering cable installation route. Subtract 10 cm for every 90° bend = required cable length.
Cable length when the cable sheath is attached to the engine exhaust pipe:
- Same procedure as above, but add 30 cm to the length.
- M66
- 8mm cable
- Up to 100 HP
M90 MACH (with blue sheath) is a high-quality and durable control cable, suitable for demanding control solutions. The renewed control cable ends and the control housing side have a patented attachment that fits several control housings. The rubber seal on the motor side cable end prevents water from entering the cable. Min. bending radius 150 mm. This new cable is a direct replacement for the M66 cable.
Replaces M66 control cable. Fits control housings:
- T85
- T71FC
- T72FC
- T73NRFC
- T932T
- M90 MACH
- 8mm cable
- Min. bending radius 150mm
- Up to 100HP
Kampanja
Flexible, multi-stranded control cable with a minimum bending radius of 200 mm. Outer sheath Ø 12.5 mm, inner cable Ø 4 mm, outer sheath Ø 6.2 mm. The specified cable length is ~ outer sheath dimension C + 56 cm.
Required cable length when using a transom or engine well mount: measure the distance from the center of the steering shaft to the center of the engine, around the steering cable installation route. Subtract 10 cm for each 90° bend = required cable length.
Cable length when the cable sheath is attached to the engine exhaust pipe: as above, but add 30 cm to the length.
Required cable length when using a transom or engine well mount: measure the distance from the center of the steering shaft to the center of the engine, around the steering cable installation route. Subtract 10 cm for each 90° bend = required cable length.
Cable length when the cable sheath is attached to the engine exhaust pipe: as above, but add 30 cm to the length.
- Flexible, multi-strand control cable
- Minimum bending radius 200mm
- Shell diameter 12.5mm
- Inner cable diameter 4mm
- From the top of the coiled wire: 6.2mm
- The given cable length is ~ shell dimension C + 56 cm.
- Length: 7'/2.1m - 18'/5.4m
The engine bay installation kit creates a neat installation by using a hard plastic conduit to route electrical and control cables to the engine. Complete preparation kit with 2" x 1.5m connection plate. Attaches with three screws and sealant (SikaFlex 291i recommended, not included in the package).
- To the engine well
- Neat installation
- Length: 1.5 meters
